Suzuki VLR1800, Service Manual

Page: 406 / 624

1K-11 Exhaust System:
12) Disengage the front muffler (10) and front exhaust
pipe.
13) Remove the exhaust pipe gaskets (13).
14) Remove the O2 sensor (14). (front and rear)
CAUTION
!
• Take care not to expose the O2 sensor to
an excessive shock.
• Take care not to twist or damage the O2
sensor lead wire.
Installation
Installation is in the reverse order of removal. Pay
attention to the following points:
• Tighten the O2 sensor (1) (front and rear) to the
specified torque.
Tightening torque
O2 sensor (a): 48 N·m (4.8 kgf-m, 34.5 lb-ft)
CAUTION
!
• Take care not to expose the O2 sensor to
an excessive shock.
• Take care not to twist or damage the O2
sensor lead wire.
• Do not apply oil or other materials to the
sensor air holes.
• Do not use an impact wrench when
installing the O2 sensor.
• Install the exhaust pipe gaskets (2) and connectors
(3).
CAUTION
!
Replace the gaskets and connectors with
new ones.
NOTE
When installing new connectors, remove all
of the old sealer from the exhaust pipe,
muffler joint and muffler. Apply the exhaust
gas sealer to both the inside and outside of
the new connector.
: Muffler seal (MUFFLER SEAL LOCTITE
5920 (commercially available) or equivalent)
10
I822H11B0035-01
13
13
I822H11B0036-01
14
I822H11B0037-01
(a)
1
I822H11B0038-01