Suzuki SWIFT RS415 2017, Service Manual

Page: 803 / 1257

Power Assisted Steering System: 6C-30
Tie-Rod End Boot On-Vehicle Inspection
S4RS0A6306008
Inspect each boot for tear. If evan a small tear is noted,
replace it with a new one.
Tie-Rod End Removal and Installation
S4RS0A6306009
Removal
1) Hoist vehicle, and then remove wheel referring to
“Wheel Removal and Installation: in Section 2D”.
2) Remove tie-rod end nut (1) from steering knuckle.
3) Disconnect tie-rod end (1) from knuckle (2) using
puller (3).
4) For ease of adjustment after installation, make
marking (1) of tie-rod end lock nut (2) position on tie-
rod end thread. Then, loosen lock nut and remove
tie-rod end (3) from tie-rod (4).
Installation
1) Install tie-rod end lock nut (1) and tie-rod end (2) to
tie-rod (3). Align lock nut with mark (4) on tie-rod
thread.
2) Connect tie-rod end to knuckle. Tighten tie-rod end
nut (1) to specified torque.
Tightening torque
Tie-rod end nut (a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
3) Inspect for proper toe referring to “Front Wheel
Alignment Inspection and Adjustment: in Section
2B”.
I3RM0A630024-
I3RM0A630025-
2
1
3
I4RS0A630040-
I4RS0A630041-
I4RS0A630042-
I3RM0A630029-