Suzuki SWIFT RS415 2017, Service Manual

Page: 750 / 1257

5C-4 Clutch:
Clutch Fluid Level Inspection
S4RS0A5306020
Refer to “Master Cylinder and Brake Fluid Level
Inspection: in Section 4A”.
Air Bleeding of Clutch System
S4RS0A5306021
CAUTION:
Brake fluid is extremely damaging to paint. If
fluid should accidentally touch painted
surface, immediately wipe fluid from paint
and clean painted surface.
Bleeding operation is necessary to remove air whenever
it entered hydraulic clutch system.
1) Fill master cylinder reservoir with brake fluid and
keep at least one-half full of fluid during bleeding
operation.
: Brake fluid (DOT 3)
2) Remove bleeder plug cap from clutch operating
cylinder (3). Attach a vinyl tube (1) to bleeder plug
(4), and insert the other end into container (2).
3) Depress clutch pedal several times, and then while
holding it depressed, push snap ring (2) and pull
pipe connector (1) one notch.
4) When fluid pressure in cylinder is almost depleted,
push pipe connector.
5) Repeat this operation until there are no more air
bubbles in hydraulic line.
6) When bubbles stop, depress and hold clutch pedal,
push pipe connector, and pull snap ring.
7) Then attach bleeder plug cap.
8) After completing bleeding operation, apply fluid
pressure to pipe line and check for leakage.
9) Replenish fluid into reservoir up to specified level.
10) Check clutch pedal for sponginess. If found spongy,
repeat entire procedure of bleeding.
I4RS0A530023-
3
4
1
2
3
I4RS0A530003-
2
1
I4RS0A530004-
I4RS0A530023-