Suzuki SWIFT RS415 2017, Service Manual

Page: 678 / 1257

5A-138 Automatic Transmission:
• Do not open rear cover seal ring too wide to attach.
• Do not damage O/D and 2nd coast brake return
spring subassembly and piston by pressing in O/D
and 2nd coast brake return spring subassembly
passing through its original installing position over 1.0
mm (0.039 in.).
Special tool
(A): 09926–96030
(B): 09946–06710
Transaxle Rear Cover (O/D and 2nd Coast Brake
Piston) Assembly Inspection
S4RS0A5106045
O/D and 2nd Coast Brake Return Spring
Subassembly
Measure free length of O/D and 2nd coast brake return
spring.
Free length of O/D and 2nd coast brake return spring
“a”: 18.99 mm (0.748 in.)
NOTE:
• Do not apply excessive force when
measuring spring free length.
• Perform measurement at several points.
Transaxle Rear Cover Bush
Measure transaxle rear cover bush bore by using special
tool.
If measured transaxle rear cover bush bore is out of
specifications, replace transaxle rear cover with new
one. In replacement, intermediate shaft subassembly
also needs to be checked. Replace intermediate shaft
subassembly, if necessary.
Special tool
(A): 09900–20605
Transaxle rear cover bush bore
Standard: 13.94 – 13.96 mm (0.549 – 0.550 in.)
1. Transaxle rear cover
1. Transaxle rear cover
I2RH0B510206-
I2RH0B510201-
I2RH0B510207-
I2RH0B510208-