Suzuki SWIFT RS415 2017, Service Manual

Page: 423 / 1257

Front Suspension: 2B-13
2) Install suspension control arm ball joint to steering
knuckle. Align ball stud groove with steering knuckle
bolt hole. Then install ball joint bolt (1) from the
direction as shown in figure. Tighten new suspension
arm ball joint nut (2) to specified torque.
Tightening torque
Suspension arm ball joint nut (a): 60 N·m (6.0
kg-m, 43.5 lb-ft)
3) Lower hoist and vehicle in non-loaded condition,
tighten control arm mounting bolts (1) to specified
torque.
Tightening torque
Control arm mounting bolt (a): 170 N·m (17.0 kg-
m, 123.0 lb-ft)
4) Confirm front wheel alignment referring to “Front
Wheel Alignment Inspection and Adjustment: ”.
Suspension Control Arm / Bushing
Disassembly and Assembly
S4RS0A2206014
Disassembly
1) Cut off bushing flange (rubber) (1) with knife.
2) Push out bushing by using hydraulic press (2) and
special tools.
Special tool
(A): 09943–76310
(B): 09913–75821
Assembly
1) Front bushing
Press-fit front bushing (1) by using special tools and
press (2).
Special tool
(A): 09943–76310
(B): 09913–75821
CAUTION:
Be sure to use new bushing.
F: Forward
1
1
I4RS0A220027-
I2RH01220054-
1, (a)
I4RS0A220028-
I4RS0A220029-
2
(A)
(B)
I4RS0A220030-