Suzuki SWIFT RS415 2017, Service Manual, Page: 256 / 1257

1C-4 Engine Electrical Devices:
Throttle Position (TP) Sensor Removal and
Installation
S4RS0A1306007
Removal
1) Disconnect negative cable at battery.
2) Disconnect TP sensor connector and remove TP
sensor from throttle body.
Installation
1) Install TP sensor (1) to throttle body.
Fit TP sensor to throttle body in such way that its
holes (3) are a little away from TP sensor screw
holes (2) as shown in the figure and turn TP sensor
counterclockwise so that those holes align.
Tightening torque
TP sensor screw (a): 2.5 N·m (0.25 kg-m, 1.8 lb-
ft)
2) Connect connector to TP sensor securely.
3) Connect negative cable to battery.
Engine Coolant Temperature (ECT) Sensor
Removal and Installation
S4RS0A1306008
Removal
1) Disconnect negative cable at battery.
2) Drain coolant referring to “Cooling System Draining:
in Section 1F”.
WARNING:
To avoid danger of being burned, do not
remove radiator cap while engine and
radiator are still hot.
Scalding fluid and steam can be blown out
under pressure if cap is taken off too soon.
3) Remove air intake pipe.
4) Disconnect connector from ECT sensor (1).
5) Remove ECT sensor from thermostat case.
Installation
Reverse removal procedure noting the following.
• Clean mating surfaces of ECT sensor and thermostat
case.
• Check O-ring for damage and replace, if necessary.
• Tighten ECT sensor (1) to specified torque.
Tightening torque
ECT sensor (a): 15 N·m (1.5 kg-m, 11.0 lb-ft)
• Connect connector to ECT sensor securely.
• Refill coolant referring to “Cooling System Flush and
Refill: in Section 1F”.
1
3
2
(a)
I3RB0A130004-
1
I2RH0B130008-
1,(a)
I2RH0B130009-