Suzuki SWIFT RS415 2017, Service Manual

Page: 1140 / 1257

9E-6 Glass / Windows / Mirrors:
NOTE:
• Do not use high pressure water.
• Do not blow compressed air directly at
adhesive applied part when drying.
• Do not use infrared lamp or like for drying.
CAUTION:
Upon completion of installation, note the
following.
• Sudden closing of door before adhesive is
completely set may cause glass to become
loose or to come off. Therefore, if door is
opened or closed before adhesive is
completely set, make sure to open all door
glasses and use proper care.
• If molding is not securely in place, hold it
down with a tape until adhesive is
completely set.
• Each adhesive has its own setting time.
• Be sure to refer to its maker’s instruction,
check setting time of adhesive to be used
and observe precautions to be taken
before adhesive is set.
• Refrain from driving till adhesive is
completely set so as to ensure proper and
sufficient adhesion.
Front Door Window Components
S4RS0A9506003
I2RH01950051-
10
6
3
1
7
11
5
2
9
8
4
I4RS0A950005-
1. Door glass 5. Door sealing cover 9. Front door window regulator mounting screw
: Tighten rear screw first, and then tighten front
screw.
2. Window regulator assembly
: Apply lithium grease 99000-25010
to sliding part.
6. Door panel 10. Front door outer weather-strip
3. Glass run 7. Front door sash 11. Door trim bracket
4. Door trim 8. Door glass mounting screw
: Tighten rear screw first, and then
tighten front screw.