Suzuki RA410, Manual

Page: 6 / 761

PRECAUTIONS
PRECAUTION FOR VEHICLES EQUIPPED
WITH A SUPPLEMENTAL RESTRAINT
(AIR BAG) SYSTEM
WARNING:
The configuration of air bag system parts are as
shown in the figure. When it is necessary to service
(remove, reinstall and inspect) these parts, be sure to
follow procedures described in SECTION 10B. Failure
to follow proper procedures could result in possible
air bag system activation, personal injury, damage to
parts or air bag system being unable to activate when
necessary.
If the air bag system and another vehicle system both
need repair, SUZUKI recommends that the air bag sys-
tem be repaired first, to help avoid unintended air bag
system activation.
Do not modify the steering wheel, dashboard, or any
other air bag system components. Modifications can
adversely affect air bag system performance and lead
to injury.
If the vehicle will be exposed to temperatures over
93
C (200 F) (for example, during a paint baking pro-
cess), remove the air bag system components before-
hand to avoid component damage or unintended air
bag system activation.
1. Air bag wire harness
2. Passenger air bag (inflator) module
3. SDM
4. Contact coil
5. Driver air bag (inflator) module
6. Seat belt pretensioner
4
5
2
1
3
6
6
DIAGNOSIS
When troubleshooting air bag system, be sure to follow
“DIAGNOSIS” in SECTION 10B. Bypassing these proce-
dures may result in extended diagnostic time, incorrect
diagnosis, and incorrect parts replacement.
Never use electrical test equipment other than that speci-
fied in this manual.
WARNING:
Never attempt to measure the resistance of the air bag
(inflator) modules (driver and passenger) and seat belt
pretentioners (driver and passenger). It is very danger-
ous as the electric current from the tester may deploy the
air bag or activate the pretensioner.
GENERAL INFORMATION 0A-3