Suzuki Liana RH413, Service Manual

Page: 876 / 1302

7B-37 Air Conditioning System: Manual Type
Installation
1) Install magnet clutch coil (2).
NOTE
Protrusion on under side of magnet clutch
coil (2) must match hole in compressor
assembly (3) to prevent movement and to
locate lead wire correctly.
2) Using special tool, install new circlip (1) as shown.
Special tool
(A): 09900-06107
3) Install clamp portion and ground terminal of lead
wire.
4) Install magnet clutch pulley (1).
a) Set magnet clutch pulley squarely over clutch
installation boss.
b) Place special tool onto magnet clutch pulley
bearing.
Ensure that edge rests only on inner race of
bearing.
Special tool
(A): 09991-06010
c) Install new circlip.
CAUTION
!
Be careful not to scratch bearing seal.
5) Adjust clearance between armature plate (1) and
magnet clutch pulley (2) by putting shim(s) on
compressor shaft.
Standard clearance between armature plate and
magnet clutch pulley “a”
0.35 – 0.6 mm (0.014 – 0.023 in.)
6) Tighten new armature plate bolt (1) to specified
torque.
Tightening torque
Armature plate nut (a): 18 N·m (1.8 kgf-m, 13.0
lb-ft)
Special tool
(A): 09920-53740
7) Install compressor to vehicle referring to
“Compressor Removal and Installation”.
I2RH01720047-01
I2RH01720048-01
2. Armature plate
“a”
1
2
I2RH01720049-01
1, (a)
2
(A)
I2RH01720050-01