Suzuki Liana RH413, Service Manual

Page: 598 / 1302

5A-50 Automatic Transmission/Transaxle:
DTC P0715 (No. 14): Input / Turbine Speed Sensor Circuit Malfunction
S3RH0A5104024
Wiring Diagram
DTC Detecting Condition and Trouble Area
DTC Confirmation Procedure
WARNING
!
• When performing a road test, select a
place where there is no traffic or
possibility of a traffic accident and be very
careful during testing to avoid occurrence
of an accident.
• Road test should be carried out with 2
persons, a driver and tester, on a level
road.
1) Connect scan tool to DLC with ignition switch OFF.
2) Clear DTCs in TCM and ECM memories by using
scan tool and start engine.
3) Shift selector lever to “D” range and drive vehicle at
50 km/h (31 mile/h) or more with 3rd gear at least for
5 minutes.
4) Stop vehicle and check DTC, pending DTC and
freeze frame data, if available.
17
5
G08 G07
G07-5
2.5V
3
GRN
RED G07-17
1
2
I2RH0B510019-01
1. TCM 2. Input shaft speed sensor 3. Terminal arrangement of TCM connector (viewed from harness side)
DTC detecting condition Trouble area
No input shaft speed sensor signal is detected although
output shaft speed sensor signals are detected. • Input shaft speed sensor or its circuit malfunction
• Improper input shaft speed sensor installation
• Damaged direct clutch drum
• Foreign material attachment to sensor or drum
• TCM