Suzuki Liana RH413, Service Manual

Page: 1221 / 1302

Security and Locks: 9F-8
Front Door Lock Assembly Removal and
Installation
S3RH0A9606002
Removal
1) Remove front door glass referring to “Front Door
Glass Removal and Installation in Section 9E”.
2) Remove key cylinder protector (1).
3) Disconnect door opening control rod (2) from outside
handle.
4) Disconnect door latch control rod (3).
5) Disconnect door lock motor lead wire (if equipped).
6) Remove door lock knob (4).
7) Loosen door latch screws (5), door latch bolt (6) and
remove door latch (7).
8) Remove key cylinder mounting bolt.
9) Remove key cylinder (8).
10) Remove key cylinder plate.
Installation
Reverse removal procedure to install front door lock
assembly noting the following instructions.
• Install key cylinder as follows:
a. Install key cylinder plate (1).
b. Tighten lower outside handle screw (2).
c. Install key cylinder (3), and then rotate it to arrow
mark (4) direction as shown.
d. Tighten upper outside handle screw (5).
• Apply grease to sliding parts of door latch assembly.
: Grease 99000–25010
• Move door latch striker (2) up or down so its center
aligns with the center of groove “A” on the door latch
assembly (1) as shown.
Striker should be moved vertically and placed level.
Do not adjust door lock.
• Move door latch striker (1) sideways to adjust door
outer panel surface (2) flush with another door outer
panel or body outer panel surface (3) as shown.
In order to correctly obtain door lock operates,
increase or decrease number of shims inserted
between body and striker (1) to adjust it.
3
7
2
8
6
5
1
4
I3RH0A960009-01
I3RH0A960010-01
3. Shaft
[A]: Front door
[B]: Rear door
I2RH01970006-01
I3RH0A960018-01