Suzuki GRAND VITARA JB416, Service Manual

Page: 361 / 474

Automatic Transmission/Transaxle: 5A-42
40) Fix valve body (1) by using bolts with each nominal
length as indicated in the figure and tightening to
specified torque.
Tightening torque
Valve body bolt: 10 N·m (1.0 kgf-m, 7.5 lb-ft)
Valve body bolt nominal length
“a”: 28 mm (1.10 in.)
“b”: 30 mm (1.18 in.)
“c”: 36 mm (1.42 in.)
“d”: 45 mm (1.77 in.)
41) Install O/D brake applying tube (1).
42) Lubricate new O-ring with A/T fluid and attach it to
grommet of solenoid wire harness. Then connect
solenoid wire harness to transmission case and fix it
with solenoid wire harness clamp. Connect each
connector to solenoid. And install new gasket and
brake applying cover.
Tightening torque
Transmission wire connector bolt (a): 16 N·m (
1.6 kgf-m, 11.5 lb-ft)
43) Connect solenoid coupler to each solenoid.
44) Install oil strainer (1) to valve body assembly.
Tightening torque
Oil strainer bolt (a): 5.5 N·m (0.55 kgf-m, 4.0 lb-
ft)
45) Install transmission oil pan (1) with new oil pan
gasket.
NOTE
Align cutout in oil pan gasket with that in
transmission case.
Tightening torque
Transmission oil pan bolt: 4.5 N·m (0.45 kgf-m,
3.5 lb-ft)
46) With wood rough key attached to output shaft, install
sensor rotor (2) by aligning its key groove with wood
rough key and install C-ring.
“a”
“a” “a”
1
“b”
“b”
“c”
“c”
“c”
“d” “d”
“d”
“d”
I5JB0A510141-01
1
I5JB0A510143-02
(a)
I5JB0A510142-01
1. C-ring
1
(a)
I5JB0A510144-01
IYSQ01510094-01
1
2
I5JB0A510072-01