Suzuki GRAND VITARA JB416, Service Manual

Page: 178 / 474

3C-61 Transfer: Motor-Shift Type (Transfer with Shift Actuator)
6) Remove front case (1) using plastic hammer.
7) Remove rear case bolts (1) and clamp (2) and then
separate center case (3) using special tool.
Special tool
(A): 09912–34510
8) Remove knock pin (1) and oil pipe (2) from center
case (4) and remove front oil seal No.1 (3) using flat
end rod or the like, if necessary.
9) Remove needle bearings (1) from center case (2)
using special tools, if necessary.
Special tool
(A): 09913–76010
(B): 09925–98210
10) Remove needle bearing (1), snap ring (2), washer
(3) and shim(s) (4) from rear output shaft (5).
11) Remove reduction shift sleeve (1), center differential
and low gear from rear output shaft (2).
12) Remove needle bearings (1), front drive shaft (2)
and thrust needle bearing (4) from rear output shaft
(3).
1
I5JB0A331014-01
1
2
I5JB0A331015-01
3
(A)
I5JB0A331106-01
1
2
3
4
I5JB0A331017-01
(A)
(B)
1
2
I5JB0A331018-01
1
2
3
4 5
I5JB0A331019-01
1
2
I5JB0A331020-02
1
1
2
3
4
I5JB0A331021-01