Adjustments
Technical Handbook
019722-101 Rev. 05
72
SC-350/360
11.2 Thickness Guide Block
The thickness guide block has two adjustment possibilities:
• height position
• parallelism (in parallel with the coin disc)
Thickness guide block - Height position
Set the thickness selector to the position “twelve a clock”. This
position corresponds to the adjustment for the thinnest coin and the
gap between the disc and the block should be 1 mm.
If not, adjust the height as follows.
a) Open the inspection cover.
a) Set thickness selector to the position twelve a clock.
b) Tighten the locking screw (1).
c) Remove the screw and the spacer (2).
d) Insert the washers (3).
Note!
The same number of washers must be inserted at the coin feed unit as
well.
e) Replace the screw and the spacer (2)
f) When the correct position (1 mm gap) is achieved, lock with the
locking screw (1).
1 Locking screw
2 Screw and spacer
3 Washer
1
3
2
