Troubleshooting
Technical Handbook
019722-101 Rev. 05
64
SC-350/360
9.3 Removing a Coin Blocking the Coin Exit
a) Switch
Off
the machine and disconnect the mains lead from the
supply socket.
b) Open the inspection cover.
c) Raise the feed mechanism (2) and the the thickness guide
block (1).
d) Carefully remove the coin blocking the coin exit.
e) Replace the thickness guide block and the feed mechanism.
f) Close the inspection cover.
Note!
The machine will not operate if the inspection cover is open.
9.4 Small Coins not Off-sorted
If small, thin coins are not off-sorted, check the position of the coin
rails (left and right), see
.
9.5 Good Coins Off-sorted
Check the coin diameter tolerances. Adjust the coin rails (left and
right), see
.
Check the coin rails. Replace them if worn, see
.
1
2
1 Thickness guide block
2 Feed mechanism
