Set-up
Technical Handbook
019722-101 Rev. 05
34
SC-350/360
6 - Service interval mode
The set-up can be in one of four modes:
•
Mode 0 - Flashing decimal point
When the machine is due for service, the decimal point at the far
left of the display flashes. This mode is displayed as “SEr 0” in
the service interval menu.
•
Mode 1 - Service message
When the machine is due for service, a service message is
displayed after switching
On
. After the message the number of
coins counted since the last run is presented. To acknowledge the
message, press
C
. The decimal point at the far left of the display
starts to flash.
The service message “CALL For SErvicE” will be displayed.
This mode is displayed as “SEr 1” in the service interval menu.
•
Mode 2 - Service message with machine disabled
When the service limit is passed by 50% or more, it is no longer
possible to acknowledge the message. To make the machine work,
clear the number of coins counted or change mode.
This mode is displayed as “SEr 2” in the service interval menu.
•
Mode 3 Service message with machine disabled
When the service limit is passed by 100% or more, it is no longer
possible to acknowledge the message. To make the machine work,
clear the number of coins counted or change mode.
This mode is displayed as “SEr 3” in the service interval menu.
Changing mode
Select the wanted mode by pressing
C
. The display will toggle
between “SEr 0”
“SEr 1”
“SEr 2”
“SEr 3”
“SEr 0” etc.
7 - Service interval demonstration mode
For demonstration purposes the service interval can be set to 100.
Note!
Before setting the “Service interval demonstration mode“, clear the
batch register by pressing
B
and
C
together.
a) Press and hold down
Q
.
b) Press and hold down
Start/Stop
. The display toggles between
“SErd” and “100”. The service interval is set to 100.
c) Release
Start/Stop
.
d) Release
Q
. The display now shows “SErd x ”.
