![background image](http://html1.mh-extra.com/html/suzohapp/arpege-security-sc-350/arpege-security-sc-350_technical-handbook_1408249031.webp)
Technical Description
Technical Handbook
019722-101 Rev. 05
21
SC-350/360
6.6 RD/AUX Interface
The RD/AUX interface board is fitted on the rear of the machine.
• A FC 3 or a BDO sachet machine can be connected to CN1.
• An RD 6, can be connected to CN2.
Refer to
“Accessories and Options” on page 10
.
External start
The
External start
(-ExtSrt) is located on the CN3, pin 16.
Full batch indication (FBI)
The FBI is located on the CN3, pin 4.
The FBI is normally high. If the machine is set for the BDO sachet
machine, FBI goes high when a full batch has been reached.
Coin feed
TrayOn
is located on the CN3, pin 8.
This signal goes high when the level of coins on the coin tray is low.
External coin pulse
Coin pulse
(CoinP) is located on the CN3, pin 6.
One
pulse is generated for each coin passing the coin detector. The
pulse is high during 7 ms, and the distance between the pulses is at
least 7 ms.
An external unit, for example a remote customer display (RD 6), can
count these pulses and show the
number
of counted coins. This
works up to a coin speed of 4,000 coins/minute. The machine can
store up to 250 coin pulses at a higher speed for a short while. If this
value is exceeded, the external unit will show an incorrect number of
coins.
Resetting a remote display
External reset
(-ExtRst) is located on the CN3, pin 2.
This signal goes low for a short time to reset a remote customer
display. This mode must be enabled in the set-up.