Technical Description
Technical Handbook
019722-101 Rev. 05
14
SC-350/360
6
Technical Description
6.1 Mechanical Description
Coin disc
The coin disc is driven by the main motor via a drive belt and a gear
assembly. On the motor shaft there is a double pulley (1) for
50/60 Hz.
The minor diameter is for 60 Hz and the other for 50 Hz.
Diameter cam
The diameter cam is mounted on the shaft of the diameter selector
and fitted edge-to-edge towards the left sorting slide guide.
Turn the diameter selector to select the
diameter
of the coins to be
counted. The left sorting slide guide is then moved in parallel
(horizontal linear motion) with the fixed right slide guide to set the
correct coin diameter gap.
Thickness cam
Turn the thickness selector knob to select the
thickness
of the coins
to be counted. The block is moved in parallel motion (vertical linear
motion) with the coin disc to set the correct coin thickness gap. The
feeding unit is also moved in the same way as the thickness unit.
Hopper unit - SC-360
The hopper unit is driven by a motor. If the coin level on the coin
disc reaches up to the coin level sensor the hopper motor will stop, it
will start again when the coin level falls below the coin level sensor.
1 Double pulley
1
