Sutron TesiMod TP22, User Manual

Page: 16 / 62

Installation and Commissioning
2-8
2.4 Switching the Device on
After you applied the supply voltage, a system test is carried out during which the
modules in the operating device are tested and initialized. All status LEDs are acti-
vated for a short time. A number of system and error messages can be output by the
system test. If the application memory contains a valid project, the first mask, i.e. the
„Start mask“ or the mask defined in the TSwin language parameters as the Start-up
mask appears on the display. A beep also sounds by the integrated loudspeaker.
The „Start mask“ is displayed for 5 seconds. This is a fixed time setting. After this time
has elapsed, the „Main mask“ or the mask defined in the language parameters as the
Main mask appears on the display. This is the first mask of the operator guidance.
When you touch the display while the „Start mask“ is displayed, the „Setup mask“ ap-
pears. In this mask you define the parameters for the interfaces and the operating
device.
2.5 Identification
You can identify the operating device by the nameplate on the rear.
Figure 2-8 Nameplate (example)
1 Order Number
2 Firmware Version (Version on Delivery)
3 Voltage and Current
4 Serial Number
Depending on the size of the display, you will be able to read various types of infor-
mation as the operating device is initialized: clock frequency, application memory
size, current firmware version, TSwin version, project name, time, date, number of
compilation runs and a random number.
1. Hold down an arbitrary key at the operating device to generate an error message.
2. Read the firmware version now.
3. Release the key to complete the initialization procedure of the operating device.
Because the initialization mask is visible only for a few seconds there is a possibility
to represent this mask for a longer time period.