Model # 12
-
8602
SUP Folding Rack
Rev. 8/19
Tools Needed : Tape Measure, Electric Drill, ¹/₈” Drill Bit, #2 Phillips
Head Driver, Stud Finder
The length of your SUP will determine arm spacing.
is 40% of total SUP length, (SUP length x 0.4 = spacing).
Locate studs where arms will be mounted and mark desired height
for the
SUP Folding Rack
at base of support arm. Use a
mounting
bracket
as a template, and a
mounting screw
to mark the locations
for holes. Wall studs are typically on 16” centers. It is important that
at least one screw from each
mounting bracket
goes into a wood
stud.
Screwing only into drywall is not sufficient and could result in
injury to self and SUP.
1.
Pre
-
drill pilot hole for
Phillips Head screw
using a ¹/₈” drill bit.
2.
The second hole will typically miss a single stud (see Photo #1).
Insert a
plastic anchor
into the hole. Note:
If you were lucky and
hit a stud on both holes, skip this step.
(continued next page)
Parts List
Qty
Name
2
SUP Folding Rack—Yellow
8
Plastic Mounting Bracket
8
Mounting Screw
4
Plastic Anchor
4
Wall Extension Plates
Holds up to 75 LBS
Customer Service:770-518-0045
Fax: 770-518-8507
Website: www.suspenz.com
Suspenz®, Inc.
8725 Roswell Road #0-220
Atlanta GA 30350
Suspenz
®
products are warrantied for life against defects in material or workmanship to the original owner. Product must
be used for its intended purpose under normal conditions. Please visit www.Suspenz.com for complete warranty
information.
OUR PLEDGE TO YOU
For Technical assistance or Replacement parts: call 866.787.7369
Scan* to see
Video Instructions
for Assembly & Use
*
QR code reader app required
Pro Tip: An old woodworkers trick is to rub the screw
threads on a bar of soap for easy installation.
Photo #1
P. 1
