Installation
VariFrame – Assembly Instructions
page 30
5.3.2.9
Installation of the electrical controller (exemplary)
Place the controller (not included in the scope of delivery) into the space between
the two cross beams or at another suitable position on the bottom surface of the
tabletop.
Make sure that the connecting cable of the lifting columns can be plugged into the
controller in any case.
Ensure that the voltage supply cable (not included in the scope of delivery) can be
plugged into the controller.
Ensure that the cable of the hand-held controller (not included in the scope of
delivery) can be plugged into the controller.
Fasten the controller to the boreholes provided on the bottom of the tabletop
between the two cross beams (2 fastening points).
Figure 21 Installation of the controller
WARNING
A risk of sustaining injuries due to protruding screws is posed.
ATTENTION
Use screws with the proper length only.
Screws that are too long will penetrate the top surface of the tabletop and damage it!
IMPORTANT
The controller must be fastened in a position that allows all lifting columns to be
connected by the motor cable!
IMPORTANT
The controller must always move with the lifting columns on their travel path!
IMPORTANT
Screws to fasten the controller to the tabletop are not included in the scope of
delivery.
