Surveon CAM4110
Network Configuration
These settings are used to configure basic network access for the camera.
They are found under Network> Network Configuration.
Most of these settings vary with your specific hardware setup; therefore the
defaults are set for common SOHO level usage. If you are using the camera in
an enterprise environment, please check with your IT department to
determine the correct settings for this section.
IP & DNS Settings
These settings are used determine the IP address of the network camera.
•
Get IP address automatically
-
Automatically acquires IP address from
a DHCP service. This is the default setting
•
Use fixed IP address
-
Sets a fixed IP address. You must also manually
fill in IP address, Subnet mask, Default gateway, Primary DNS, and
Secondary DNS fields. The network camera can be connected to the
network upon completion.
PPPoE Settings
This feature is disabled by default. Connecting to the network using PPPoE
requires a user name and password from your ISP. Select Enable PPPoE and
fill in valid user name and password to connect the camera to the Internet.
DDNS Settings
DDNS (Dynamic Domain Name Server) is a protocol that enables the camera
to
maintain a static connection address, even when its IP changes. Access
using this feature is disabled by default.
Connecting using DDNS requires registration on third-party websites for DDNS
services. Select desired DDNS service website, check the Enable DDNS
option, and fill in valid user name and password. You can then access the
camera through the registered domain name.
Click OK to save or Cancel to abort the changes before you leave the page.
www.surveon.com
24
