8
STARTING THE DISPENSER
NOTE:
•
Before starting the dispenser, make certain that all Installation instructions have been
followed and that the dispenser has been sitting upright for a minimum of 3 hours.
To start the dispenser:
1. Plug the power cord into the proper electrical outlet.
2. With the dispenser drawer closed, turn the Power Switch “ON”.
•
The power switch is located at the lower left side of the dispenser. For
location of the switch, see page 3.
•
The Status Indicator Light on the front of the dispenser is an LED which
glows green when the dispenser is on and has reached operating
temperature.
3. Allow the dispenser to run empty for one hour to achieve a cold temperature
before placing product containers in the dispenser. The temperature control has
been pre-set at the factory. You can feel the cold temperature by placing your
hand on the top or back wall of the refrigeration compartment.
4. If the dispenser does not appear to be getting cold, check to make sure that it is
plugged in and that the power source is active. If the dispenser still does not
operate, immediately call the A. C. Dispensing Equipment Inc. Technical
Assistance Center at 1-888-777-9990 or 1-902-865-9602.
OPEN THE DISPENSER
DRAWER
1. Grasp the bottom front of the dispenser drawer.
2. Pull the drawer out.
Green = ON and Ready
