19
CLEANING: Roller Plate, Motor Guard Plate
1, Remove the enclosure plate:
a. Undo the 2 latches that hold the plate in place.
b. Remove the plate by lifting it up and out from the 4 bottom slots.
c. Set the plate aside to go in dishwasher or to be washed by hand.
2. Remove the empty product bag (if one is still in dispenser):
a. Slide the dispense tip out of its groove at the bottom of the drawer.
b. Unhook the top of the bag from the 3 hooks at the top of the drawer.
c. Lift the bag up and out of the drawer.
d. Discard the empty bag.
3. Remove the roller:
a. Grasp the roller.
b. Slide the roller out of the end slots.
c. Set the roller aside to wash by hand. See Instructions below.
4. Remove the motor guard plate, if necessary:
a. Lift it up by the lip at the bottom of the plate.
b. Swing the plate out from the bottom.
c. Lower the plate from the top slots.
d. Remove the plate.
e. Set the plate aside to go in the dishwasher or to be washed by hand.
•
Do not touch the rods behind the motor guard plate, if no product is spilled on
them.
5. Clean:
•
The roller plate and the motor guard plate may be washed in a commercial
dishwasher on the full wash cycle.
•
If your location does not have a dishwasher, the roller plate and the motor guard
plate must be washed and sanitized by hand (see below).
6. Drain thoroughly.
7. Air dry thoroughly.
Hand Wash: To wash the roller plate and the motor guard plate by hand:
1, Rinse with lukewarm water.
2. Wash thoroughly in a hot water wash at a minimum temperature of 140 °F or 60 °C.
Add a good quality general cleaner at concentrations recommended by the detergent
supplier.
3. Rinse well with lukewarm potable water.
4. Sanitize with a mild sanitizer recommended by your detergent supplier.
5. Drain thoroughly.
6. Air dry thoroughly.
CLEANING: Dispense Tip Area
NOTE: Do not use any abrasive cleaning materials.
When the drawer is removed, inspect the dispense tip area and clean if required.
Spilled topping may be removed easily with a damp warm or hot cloth.
1. Use a clean cloth dipped in warm water to wipe up the area around the dispense tip.
2. Use a clean cloth dipped in hot, soapy water to clean the area.
3. Use a clean cloth dipped in warm water to rinse the area.
4. Use a clean cloth dipped in an approved sanitizing solution to wipe down the area.
5. Air dry thoroughly.
