CM2000-WL 55dB
Dual Band Wireless
SOHO Amplifier
User Manual
Model: CM2000-WL 55 dB
FCC ID: RSNDUAL-62UNDER
Canada IC: 7784A-D60UNDER
CONTENTS OF THE PACKAGE
fdgbsddg
1.
CM2000-WL 55dB amplifier
2.
Right angle antenna with FME female connector
3.
110V AC power adaptor
4.
Velcro and screw mounting kits
5.
User manual (this document)
WHOLE PACKAGE OPTION:
fdgbsddg
Whole package includes Outdoor and Indoor antennas as well
as two CM240 cables as required for full operation. See picture
below.
Please
consult
the
Cellphone-Mate
website
(
www.Cellphone-Mate.com
) or call toll free at 888-365-MATE.
1. CM2000-WL 55dB: 55dB Amplifier with Power Supply
2. CM004-20-FN: 20ft CM240 Cable
3. CM004-40-FN: 40ft CM240 Cable
4. CM222(or CM222W): Dome Indoor Antenna
5. CM100-S(or CM288W): Fiber Glass Outdoor Antenna
SAFETY NOTES
fdgbsddg
This product has been tested by the Federal Communications
Commission (FCC) and found to comply with RF Exposure
Requirements Pursuant to FCC Part 24. In order to comply with the
FCC RF exposure requirements,
the user’s body should always
be separated from the antenna of the Amplifier by at least 25cm
(10’’).
Don't expose this product to extreme high or low temperature. For
example, putting the Amplifier under direct sunlight for too long may
cause it to overheat, thereby damaging the electronic components
inside.
There are no consumer serviceable or modifiable parts inside this
Amplifier product. Alteration or abuse of the Amplifier or other
components will void this product’s warranty, and could be
dangerous to the user.
CONNECTING THE AMPLFIER
sddg
The signal is received by the outside antenna from the cell tower,
then AMPLIFIED and transmitted to your phone through the inside
antenna. When the phone transmits, the signal is received by the
inside antenna, then AMPLIFIED and transmitted to the cell tower
through the outside antenna.
Connect the Inside Antenna:
The indoor dome antenna is always
recommended over the patch antenna. First, please mount dome
antenna on the ceiling, and using CM240 cable, connect the dome
antenna to the side of amplifier that marked “INDOOR”. Be sure to
tighten it.
If patch antenna is selected over dome antenna:
The patch
antenna is intended for indoors use only. Do not mount on a surface
within 4 inches of metal. Screw the patch antenna to the amplifier
connector that marked “
INDOOR
” and make sure to tighten it.
If the patch antenna is selected over dome antenna:
The patch
antenna is intended for indoors use only. Do not mount on a surface
within 4 inches of metal. Screw the patch antenna to the amplifier
connector marked “
INDOOR
” and make sure to tighten it.
Connect the Outside Antenna:
The CM100-S fiberglass antenna
is for outdoor use only. Select an outside mounting location. For best
performance, try to keep the antenna on top of the house. The
outside antenna should be located in an area with at least a 12”
radius clear of obstructions, and other radiating elements. Using the
CM240 cable,
connect the outside antenna to the “
OUTDOOR”
connector of the amplifier and tighten it.
NOTE:
Keep the separation distance between the inside and outside
antennas at least 60 feet apart if possible.
WARNING:
The outside antenna must not be co-located or
operating in conjunction with any other antenna or amplifier.
Connect the Power Cord:
To prevent damage to the Amplifier,
before plugging in the Amplifier to an AC power outlet, make sure
the Amplifier’s power switch is in the OFF position. Then connect
the power cords to the Amplifier first, and then connect the plug to
110V AC power outlet. Make sure that all of the connections to the