Disconnect the black and red switch power leads at the
battery. Cut the red and black switch leads close to the
strain relief at the switch. Strip each cut end 1/4-inch.
Crimp a quick disconnect terminal onto the stripped
end of each switch lead. Remove the red or blue and
black or yellow motor leads from the rear of the switch
bracket. Cut off the ring terminals from each lead.
Strip each cut end 1/4 inch. Crimp a quick disconnect
terminal onto the stripped end of each motor lead.
Remove and discard the old switch and bracket.
Refer to the figure for wiring diagram.
Wire terminals must be properly
installed on the switch. Improper
installation will result in high
resistance connections that
could lead to excessive heat.
Installation Instructions for Rocker Switch Retrofit Kit P/N 2233B
Contents:
Installation:
87-10928 Rev - 11/12/04
Description Qty
Rocker Switch
1
Switch Mounting Box
1
Mounting Bracket and Hardware Kit
1
1/4-inch Quick Disconnect terminal
4
Split Loom Tubing
2
Sealed Circuit Breaker
1
Battery Connection Wire
1
Terminal Boots
2
TM
1 To Motor Yellow
2 red to battery (+)
4 black to battery (–)
3 To Motor Blue
WARNING
!
1 To Motor Yellow
1
2
2 red to battery (+)
2 Red
4
4 black to battery (–)
4 Black
3
3 To Motor Blue
3 Blue
1 Yellow
+ BAT
Note
: This kit is designed specifically
for Superwinch 2.5 inch motors.
