Supero 2027R-WRF, User Manual

Page: 12 / 132

1-2
SUPERSERVER 2027R-WRF USER'S MANUAL
1-2 Serverboard Features
At the heart of the SuperServer 2027R-WRF lies the X9DRW-iF, a dual processor
serverboard based on the Intel PCH C602/C606 chipset. Below are the main
features of the X9DRW-iF. (See Figure 1-1 for a block diagram of the chipset).
Processors
The X9DRW-iF supports single or dual E5-2600 Series processors in
Socket R LGA2011 type sockets. Please refer to our web site for a complete listing
of supported processors (
www.supermicro.com ).
Memory
The X9DRW-iF has sixteen (16) single/dual/tri/quad channel 240-pin DIMM sockets
that can support up to 512 GB of DDR3 1600/1333/1066/800 MHz speed registered
ECC RDIMM/LRDIMM SDRAM in two-channel memory bus. Memory sizes of
1 GB, 2 GB, 4 GB, 8 GB, 16 GB and 32 GB size @ 1.35V/1.5V voltages are
supported. Please refer to Chapter 5 for installing memory.
N o t e :
L R D I M M ( R e d u c e d L o a d ) m e m o r y s u p p o r t s o n l y
DDR3 1333/1066/800 MHz speed memory.
Serial ATA
An on-chip (PCH C602) SATA controller is integrated into the X9DRW-iF to provide
a ten-port SATA subsystem (two SATA 3.0, four SATA 2.0 ports and four SCU
SATA2 ports), which is RAID 0, 1, 5 and 10 (Windows SATA) or RAID 0, 1 and 10
(LINUX) supported. The SATA drives are hot-swappable units.
Note:
You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Onboard Controllers/Ports
The color-coded I/O ports on the X9DRW-iF include two COM ports (one header
and one port), a VGA (monitor) port, six USB 2.0 ports (4x rear, 1x header for two
front panel), two gigabit Ethernet ports and one dedicated IPMI LAN port.
Note 1:
For more information on IPMI con fi guration, please refer to the IPMI User's
Guide posted on our website at http://www.supermicro.com/support/manuals/