13
Chapter 1: Introduction
Note:
Table is continued on the next page.
Quick Reference Table
Jumper
Description
Default Setting
JBT1
CMOS Clear
Open (Normal)
JP1
JSEN1/JIPMB1 Select
Pins 1-2 (JSEN1)
JPG1
VGA Enable/Disable
Pins 1-2 (Enabled)
JPL1
LAN1 Enable/Disable (LAN I210)
Pins 1-2 (Enabled)
JPL2
LAN2 Enable/Disable (LAN I210)
Pins 1-2 (Enabled)
JPME2
Manufacturing Mode Select
Pins 1-2 (Normal)
JPTG1
LAN X550 Enable/Disable
Pins 1-2 (Enabled)
JWD1
Watch Dog Timer
Pins 1-2 (Reset)
LED
Description
Status
LE6
Power Ready LED
Solid Amber: Standby
Solid Red: Power Failed
Solid Green: Power On
LE2401
Unit Identifier (UID) LED
Solid Blue: Unit Identified
LEDEC1
Embedded Controller (EC) Heartbeat LED
Blinking Green: EC Normal
LEDM1
BMC Heartbeat
Blinking Green: BMC Normal
LEDPWR
Onboard Power LED
Solid Green: Power On
Connector
Description
BMC_LAN
Dedicated BMC LAN Port
BT1
Onboard Battery
FAN1 - FAN6
CPU/System Fan Headers
I-SATA4 - I-SATA7
Intel PCH SATA 3.0 Ports
I-SGPIO2
Serial Link General Purpose I/O Header
JCOM1, JCOM2
COM Port, COM Header
JD1
Speaker/Power LED Header (Pins 1-2: Power LED, Pins 4-7: Speaker)
JF1
Front Control Panel Header
JL1
Chassis Intrusion Header
JLAN1, JLAN2
1G (-F), 10G (-TF) LAN Ports
JPI
2
C1
Power System Management Bus (SMB) I
2
C Header
JPWR1
24-pin ATX Power Connector
JPWR2
8-pin Power Connector
JSATA1
Intel PCH SATA 3.0 Port (I-SATA0-3)
JSD1, JSD2
SATA DOM Power Connectors
JSEN1/JIPMB1
System Front Inlet Temperature Sensor/BMC External I2C Header (for an IPMI card)
(Set pins 1-2 on JP1 for JSEN1 (Default), or pins 2-3 for JIPMB1)
JSTBY1
Standby Power Header
