12
X10SDE-DF User Manual
Note:
The table above is continued on the next page.
Motherboard Features
CPU
•
Intel® Xeon D, Pentium processor in a System-on-Chip (SoC) (one per node)
Note:
Both CPUs need to be installed for full access to the PCI-E slot, DIMM slots, and onboard controllers. Refer
to the block diagram on page 18 to determine which slots or devices may be affected.
Memory
Eight (8) 288-pin DIMM slots (four per node) support up to:
•
128GB of VLP ECC 2400/2133/1866/1600/1333MHz RDIMM memory.
•
64GB of VLP ECC 2133/1866/1600/1333MHz UDIMM memory.
Note
: 2400MHz is only supported when using 16GB DDR4 RDIMM ECC memory
DIMM Size
•
32GB, 16GB, 8GB, and 4GB, up to 128GB for RDIMM memory or up to 64GB for UDIMM memory at 1.2V
Note 1:
Memory speed support depends on the processors used in the system.
Note 2:
For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Expansion Slots
•
One (1) hard drive backplane connector (J27)
Network
•
Intel i350 dual 1Gb Ethernet ports
•
One (1) dedicated IPMI 2.0 LAN located on the front I/O panel
BaseBoard Management Controller (BMC)
•
ASpeed AST 2400 Baseboard Controller (BMC) supports IPMI 2.0
Graphics
•
Graphics controller via ASpeed AST2400 BMC
I/O Devices
•
Serial (COM) Port
•
One (1) serial port on the front I/O panel via KVM
•
SATA 3.0
•
Two (2) SATA 3.0 connectors (per node) to HDD via back panel
•
RAID (PCH)
•
RAID 0, 1, 10
•
Video (VGA)
•
One (1) on the front I/O panel via KVM
Peripheral Devices
•
Two (2) USB 2.0 ports (through KVM connector)
Motherboard Features
