Supermicro SUPERSERVER 6021F, User Manual

Page: 39 / 116

Chapter 5: Installation
5-5
Installation
5-4 I/O Ports
The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 5-2 below for the colors and locations of the various I/O ports.
Parallel Port
(Burgundy)
COM1 COM2 Keyboard
(Purple)
Mouse
(Green)
USB
Ports
(Black)
Ethernet
Port
(Black)
(Turquoise)
5-5 Installing Processors
Avoid placing direct pressure to the top of the pro
cessor package. Always connect the power cord last
and always remove it before adding, removing or
changing any hardware components.
1. Installing the FCPGA processors:
The P3TDE6 has two 370-pin sockets, which support single or dual Intel
Pentium
®
III FCPGA 500 MHz-1.26+ GHz processors and single or dual
low power Pentium
®
III processors at front bus speeds of 100 and 133
MHz. Lift the lever on the FCPGA socket and insert the processor (with
the heat sink attached) keeping the notched corner oriented toward pin
one on the socket. Make sure the processor is fully seated in the socket
and then close the lever. You can also install a single processor on the
motherboard without changing any jumper settings. (See Figure 5-3 for
views of a 370-pin FCPGA socket before and after processor installa-
tion.)
!
Figure 5-2 P3TDE6 Rear Panel I/O Ports