Supermicro SUPERSERVER 6021F, User Manual

Page: 113 / 116

C-1
Appendix C: System Specifications
Appendix C
System Specifications
Processors
Single or dual Pentium
®
III FCPGA 500 MHz-1.26+ GHz processors and
low power single or dual Pentium
®
III processors at front bus speeds
of 133 and 100 MHz.
Note: Please refer to the support section of our web site for a complete listing of supported
processors. (http://www.supermicro.com/TechSupport.htm)
Chipset
ServerWorks ServerSet III HE Super Light
BIOS
4 Mb AMI
®
Flash ROM
APM 1.2, DMI 2.1, PCI 2.2, ACPI 1.0, Plug and Play (PnP)
Memory Capacity
Four 168-pin DIMM sockets supporting up to 4 GB registered ECC
SDRAM
Note 1: The memory speed must match the front side bus speed being used.
(Both 133 or 100 MHz.)
Note 2: The DIMM slots on the P3TDER are set at a 25
°
angle to provide a low
vertical profile.
Note 3: Memory Modules should be installed in pairs (first in the two slots of
Bank0, then in both slots of Bank1, if needed).
DIMM Sizes
128 MB / 256 MB / 512 MB / 1 GB DDR-RAM PC100/133 modules
supported
SCSI Controller
Adaptec AIC-7892 for single channel Ultra160 SCSI onboard P3TDE6