40
SuperServer 5039MS-H12NR User's Manual
4.2 Headers and Connectors
Universal Serial Bus (USB) Ports
There are two Universal Serial Bus 2.0 ports (USB0/1) supported by JKVM1 on the I/O back
panel and can be used to provide rear USB access. An additional USB 3.0 type "A" port
(USB2) is located on the motherboard. Cables are not included.
Back Panel USB0/1 (2.0)
Pin Definitions
Pin #
Definition
Pin #
Definition
1
+5V
5
+5V
2
USB_N
6
USB_N
3
USB_P
7
USB_P
4
Ground
8
Ground
SATA Ports
One Serial ATA (SATA) 3.0 connector is through the sled backplane on J22 for 2280 SATA
M.2 connection. Additionally, there is one SATA 3.0 receptacle connector at I-SATA6 for SATA
DOM connection.
Note:
The system can only support SATA M.2 connections - not PCI-E 3.0.
Note:
I-SATA6 is a Supermicro SuperDOM. This is a yellow SATA DOM connector with power
pins built in and do not require separate external power cables. This connector is backward-
compatible with non-Supermicro SATADOMs that require an external power supply.
Note:
I-SATA2 J22 requires an Add-On Module (AOM) for a hard drive connection.
Note:
For more information on the SATA HostRAID configuration, please refer to the Intel
SATA HostRAID user's guide posted on our website at
http://www.supermicro.com
.
NVMe Ports
Four PCI-E 3.0 connections are through the sled backplane on J22 for NVMe U.2 connection.
