SuperServer 5039MA8/16-H12RFT User's Manual
20
2.3 Installing the Rails
There are a variety of rack units on the market, which may require a slightly different assembly
procedure. Also refer to the installation instructions that came with the rack.
This rail set fits a rack between 28" and 33.5" deep.
Do not use a two post "telco" type rack.
1. Identify the left rail set and right rail set, as they are different.
2. Position the template at the front of the system to determine the locations of the screws
for the rails.
3. In each rail set, the two sections are screwed together to keep them immobile during
shipping. Release these screws just enough to allow the rail sections to slide apart. Note
the arrow on the rail, which indicates the end that attaches to the front of the rack.
4. Slide the rails sections apart to match the depth of the rack. Position the rails with the
template and secure the front of each to the front of the rack with two flathead screws,
then secure the back of each rail to the rear of the rack with two flathead screws (see
Figure 2-2).
5. Tighten the screws that keep the two rail sections from sliding.
Figure 2-1. Placing the Template
