SuperServer 5019P-MT/MTR User's Manual
36
35
Chapter 3: Maintenance and Component Installation
PCI Expansion Card Installation
The system includes one pre-installed riser card: RSC-RR1U-E16, for a standard size PCI-E
x16 card. Riser cards position the expansion cards at a 90 degree angle, allowing them to
fit inside the 1U chassis.
Installing PCI Expansion Cards
The riser card has already been pre-installed into the motherboard. Perform the following
steps to install an add-on card:
Begin by removing power from the system as described in section 3.1.
1. Remove the chassis cover to access the inside of the system.
2. Remove the PCI slot shield on the chassis by releasing the locking tab.
3. Insert the expansion (add-on) card into the riser card.
4. Secure the card with the locking tab.
3.4 Chassis Components
Front Bezel
If your system has an optional bezel attached to the front of the chassis, you will need to
remove it to gain access to the drive bays.
1. Unlock the front of the chassis and then press the release knob.
2.
Carefully remove the bezel with both hands. A filter located within the bezel can be
removed for replacement/cleaning.
It is recommended that you keep a maintenance log to list filter cleaning/replacement dates,
since its condition affects the airflow throughout the whole system.
