28
SuperServer 5019D-FN8TP User's Manual
Installing 2.5" Fixed Hard Drives
You can install between one and four 2.5" HDDs in various configurations. If two or fewer
2.5" HDDs are installed, you can also add a full-height, half-length PCI-E expansion card.
If you want to install four 2.5" HDDs, two dual 2.5" fixed HDD brackets are required. Refer
to the parts list table in Section 1.1.
Installing 2.5" Hard Drives
Begin by removing power from the system as described in Section 3.1 and removing the
cover as described in Section 3.2.
1. Install the hard drives into the hard drive brackets and secure them with the screws
provided.
2. Place the hard drives and brackets into the chassis as illustrated in Figure 3-4. Orient
two or more drives with the cable connections facing the inside of the chassis.
3. Secure the hard drive brackets to the chassis floor by inserting the screws upward
through the underside of the chassis.
4. Connect the hard drive wiring.
5. Reinstall the chassis cover and restore power to the server.
Figure 3-4. Four 2.5" HDDs in Two Brackets, No Expansion Card