Chapter 21: SNMP Commands
– 740 –
E
XAMPLE
This example first creates an entry for a remote host, and then instructs
the switch to record this device as the remote host for the specified
notification log.
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#snmp-server notify-filter A1 remote 10.1.19.23
Console#
show nlm
oper-status
This command shows the operational status of configured notification logs.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#show nlm oper-status
Filter Name: A1
Oper-Status: Operational
Console#
show snmp
notify-filter
This command displays the configured notification logs.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
This example displays the configured notification logs and associated
target hosts.
Console#show snmp notify-filter
Filter profile name IP address
---------------------------- ----------------
A1 10.1.19.23
Console#
Additional Trap Commands
memory
This command sets an SNMP trap based on configured thresholds for
memory utilization. Use the
no
form to restore the default setting.
S
YNTAX
memory
{
rising
rising-threshold
|
falling
falling-threshold
}
no memory
{
rising
|
falling
}
rising-threshold
- Rising threshold for memory utilization alarm
expressed in percentage. (Range: 1-100)
Summary of Contents for SSE-G2252
