Chapter 20: System Management Commands
Event Logging
– 691 –
S
YNTAX
logging host
host-ip-address
[
port
udp-port
]
no logging host
host-ip-address
host-ip-address
- The IPv4 or IPv6 address of a syslog server.
udp-port
- The UDP port number used by the remote server.
(Range: 1-65535)
D
EFAULT
S
ETTING
UPD Port: 514
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
Use this command more than once to build up a list of host IP
addresses.
•
The maximum number of host IP addresses allowed is five.
E
XAMPLE
Console(config)#logging host 10.1.0.3
Console(config)#
logging on
This command controls logging of error messages, sending debug or error
messages to a logging process. The
no
form disables the logging process.
S
YNTAX
[
no
]
logging on
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The logging process controls error messages saved to switch memory or
sent to remote syslog servers. You can use the
command to
control the type of error messages that are stored in memory. You can use
the
command to control the type of error messages that are
sent to specified syslog servers.
E
XAMPLE
Console(config)#logging on
Console(config)#
Summary of Contents for SSE-G2252
