Chapter 20: System Management Commands
Line
– 685 –
Console(config-line)#speed 57600
Console(config-line)#
stopbits
This command sets the number of the stop bits transmitted per byte. Use
the
no
form to restore the default setting.
S
YNTAX
stopbits
{
1
|
2
}
no
stopbits
1 - One stop bit
2 - Two stop bits
D
EFAULT
S
ETTING
1 stop bit
C
OMMAND
M
ODE
Line Configuration
E
XAMPLE
To specify 2 stop bits, enter this command:
Console(config-line)#stopbits 2
Console(config-line)#
timeout login
response
This command sets the interval that the system waits for a user to log into
the CLI. Use the
no
form to restore the default setting.
S
YNTAX
timeout login response
[
seconds
]
no timeout login response
seconds
- Integer that specifies the timeout interval.
(Range: 10 - 300 seconds)
D
EFAULT
S
ETTING
300 seconds
C
OMMAND
M
ODE
Line Configuration
C
OMMAND
U
SAGE
•
If a login attempt is not detected within the timeout interval, the
connection is terminated for the session.
•
This command applies to both the local console and Telnet connections.
Summary of Contents for SSE-G2252
