Supermicro SSE-G2252, User Manual

Page: 503 / 1401

Chapter 14: Basic Administration Protocols
OAM Configuration
– 510 –
W
EB
I
NTERFACE
To display information about attached OAM-enabled devices:
1.
Click Administration, OAM, Remote Interface.
Figure 14-95: Displaying Status of Remote Interfaces
C
ONFIGURING A
R
EMOTE
L
OOP
B
ACK
T
EST
Use the Administration > OAM > Remote Loopback (Remote Loopback
Test) page to initiate a loop back test to the peer device attached to the
selected port.
CLI R
EFERENCES
•
“efm oam remote-loopback” on page 1314
•
“efm oam remote-loopback test” on page 1315
C
OMMAND
U
SAGE
• You can use this command to perform an OAM remote loop back test on
the specified port. The port that you specify to run this test must be
connected to a peer OAM device capable of entering into OAM remote
loop back mode.
• During a remote loop back test, the remote OAM entity loops back
every frame except for OAMPDUs and pause frames.
• OAM remote loopback can be used for fault localization and link
performance testing. Statistics from both the local and remote DTE can
be queried and compared at any time during loop back testing.
• To perform a loopback test, first enable Remote Loop Back Mode, click
Test, and then click End. The number of packets transmitted and
received will be displayed.
P
ARAMETERS
These parameters are displayed:
Loopback Mode of Remote Device
•
Port – Port identifier. (Range: 1-52)