Supermicro SSE-G2252, User Manual

Page: 177 / 1401

Chapter 7: Address Table Settings
Setting Static Addresses
– 181 –
4.
Click Apply.
Figure 7-2: Configuring MAC Address Learning for a VLAN
S
ETTING
S
TATIC
A
DDRESSES
Use the MAC Address > Static page to configure static MAC addresses. A
static address can be assigned to a specific interface on this switch. Static
addresses are bound to the assigned interface and will not be moved.
When a static address is seen on another interface, the address will be
ignored and will not be written to the address table.
CLI R
EFERENCES
• “mac-address-table static” on page 1104
C
OMMAND
U
SAGE
The static address for a host device can be assigned to a specific port
within a specific VLAN. Use this command to add static addresses to the
MAC Address Table. Static addresses have the following characteristics:
•
Static addresses are bound to the assigned interface and will not be
moved. When a static address is seen on another interface, the address
will be ignored and will not be written to the address table.
•
Static addresses will not be removed from the address table when a
given interface link is down.
•
A static address cannot be learned on another port until the address is
removed from the table.
P
ARAMETERS
These parameters are displayed:
•
VLAN – ID of configured VLAN. (Range: 1-4094)
•
Interface – Port or trunk associated with the device assigned a static
address.
•
MAC Address – Physical address of a device mapped to this interface.
Enter an address in the form of xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
•
Static Status – Sets the time to retain the specified address.