Chapter 42: OAM Commands
– 1313 –
S
YNTAX
efm oam mode
{
active
|
passive
}
no efm oam mode
active
- All OAM functions are enabled.
passive
- All OAM functions are enabled, except for OAM discovery,
and sending loopback control OAMPDUs.
D
EFAULT
S
ETTING
Active
C
OMMAND
M
ODE
Interface Configuration
C
OMMAND
U
SAGE
When set to active mode, the selected interface will initiate the OAM
discovery process. When in passive mode, it can only respond to discovery
messages.
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam mode active
Console(config-if)#
clear efm oam
counters
This command clears statistical counters for various OAMPDU message
types.
S
YNTAX
clear efm oam counters
[
interface-list
]
interface-list
-
unit
/
port
unit
- Unit identifier. (Range: 1)
port
- Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-52)
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#clear efm oam counters
Console#
R
ELATED
C
OMMANDS
Summary of Contents for SSE-G2252
