Supermicro SSE-G2252, User Manual

Page: 1235 / 1401

Chapter 40: LLDP Commands
– 1248 –
seconds - Amount of packets. (Range: 1-10 packets;
Default: 4 packets)
D
EFAULT
S
ETTING
4 packets
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
This parameter is part of the timer which ensures that the LLDP-MED Fast
Start mechanism is active for the port. LLDP-MED Fast Start is critical to
the timely startup of LLDP, and therefore integral to the rapid availability of
Emergency Call Service.
E
XAMPLE
Console(config)#lldp med-fast-start-count 6
Console(config)#
lldp
notification-interval
This command configures the allowed interval for sending SNMP
notifications about LLDP MIB changes. Use the no form to restore the
default setting.
S
YNTAX
lldp notification-interval seconds
no lldp notification-interval
seconds - Specifies the periodic interval at which SNMP notifications
are sent. (Range: 5 - 3600 seconds)
D
EFAULT
S
ETTING
5 seconds
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
•
This parameter only applies to SNMP applications which use data stored
in the LLDP MIB for network monitoring or management.
•
Information about changes in LLDP neighbors that occur between SNMP
notifications is not transmitted. Only state changes that exist at the
time of a notification are included in the transmission. An SNMP agent
should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.