Supermicro SSE-G2252, User Manual

Page: 1224 / 1401

Chapter 39: Multicast Filtering Commands
MVR for IPv6
– 1237 –
E
XAMPLE
The following statically assigns a multicast group to a receiver port:
Console(config)#interface ethernet 1/2
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 2 group ff00::1
Console(config-if)#
clear mvr6 groups
dynamic
This command clears multicast group information dynamically learned
through MVR6.
S
YNTAX
clear mvr6 groups dynamic [ domain domain-id ]
domain-id - An independent multicast domain. (Range: 1-5)
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
This command only clears entries learned though MVR6. Statically
configured multicast addresses are not cleared.
E
XAMPLE
Console#clear mvr6 groups dynamic
Console#
clear mvr6 statistics
Use this command to clear the MVR6 statistics.
S
YNTAX
clear mvr6 statistics [ interface { ethernet unit/port |
port-channel channel-id | vlan vlan-id} ]
ethernet unit / port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-52)
port-channel channel-id (Range: 1-16)
vlan vlan-id (Range: 1-4094)
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
If the interface option is not used then all MVR6 statistics are cleared.
Otherwise using the interface option will only clear the MVR6 statistics of
the specified interface.