Supermicro SSE-G2252, User Manual, Page: 1192 / 1401

Chapter 39: Multicast Filtering Commands
MVR for IPv4
– 1205 –
mvr
This command enables Multicast VLAN Registration (MVR) globally on the
switch. Use the no form of this command to globally disable MVR.
S
YNTAX
[ no ] mvr
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
mvr profile Maps a range of MVR group addresses to a profile GC
mvr proxy-query-interval Configures the interval at which the receiver port
sends out general queries.
GC
mvr proxy-switching Enables MVR proxy switching, where the source port
acts as a host, and the receiver port acts as an MVR
router with querier service enabled
GC
mvr robustness-value Configures the expected packet loss, and thereby the
number of times to generate report and group-specific
queries
GC
mvr source-port-mode
dynamic
Configures the switch to only forward multicast
streams which the source port has dynamically joined
GC
mvr upstream-source-ip Configures the source IP address assigned to all
control packets sent upstream
GC
mvr vlan Specifies the VLAN through which MVR multicast data
is received
GC
mvr immediate-leave Enables immediate leave capability IC
mvr type Configures an interface as an MVR receiver or source
port
IC
mvr vlan group Statically binds a multicast group to a port IC
clear mrv groups dynamic Clears multicast group information dynamically
learned through MVR
PE
clear mrv statistics Clears MRV statistics PE
show mvr Shows information about MVR domain settings,
including MVR operational status, the multicast VLAN,
the current number of group addresses, and the
upstream source IP address
PE
show mvr
associated-profile
Shows the profiles bound the specified domain PE
show mvr interface Shows MVR settings for interfaces attached to the MVR
VLAN
PE
show mvr members Shows information about the current number of
entries in the forwarding database, or detailed
information about a specific multicast address
PE
show mvr profile Shows all configured MVR profiles PE
show mvr statistics Shows MVR protocol statistics for the specified
interface
PE
Table 39-11: Multicast VLAN Registration for IPv4 Commands (Continued)
Command Function Mode