21
Chapter 2 Maintenance and Component Installation
Figure 2-7. Installing a Peripheral Drive
2.5 Installing a Peripheral Device
The DS3A-261B chassis has two bays for optional peripheral devices, such as a DVD drive.
Installing a Peripheral Device
1. Power down the system and remove the power cord from the rear of the power supply
as described in Section 2.1 and remove the chassis cover as described in Section 2.2.
2. Remove the front bezel as described in Section 2.4
3. Remove the peripheral drive bay's cover plate in the front bezel by pressing the
cover plate release tab on the inside of the bezel in an inward direction to release the
peripheral drive bay cover.
4. Replace the front bezel on the chassis as described in Section 2.4.
5. Slide the peripheral device through the opening in the front bezel into the chassis bay.
6. If desired, screws may be used where indicated below to secure the optical device into
chassis.
7. Plug the power cord into the rear of the power supply, replace the chassis cover and
power up the system.
Optional Screw
Mounting Holes
