IG52-DB Heavy Duty Enclosed Robot
SuperDroid Robots, Inc
Contact
224 Technology Park Lane
(919) 557-9162
Fuquay Varina, NC 27526
Revised: February 8, 2019
Page 12 of 13
Figure 13: Motor Wiring and Motor Controller Circuit
Operation
1.
Before powering on the robot make sure it is up on blocks so the wheels can spin freely. Occasionally
some or all of the wheels start as soon as the motor controller gets power. In this case the settings of the
motor controller need to be changed.
2.
Make sure to use the correct DIP switch settings. If using R/C mode switch 1 should be DOWN (closest to
the number) and all other switches should be UP. If using a different mode see the manual for the motor
controller you are using on Dimension Engineering’s website.
Binding a Spektrum Remote
3.
Insert the bind plug into the receiver and power on the robot.
4.
While pressing the Bind button, power on the transmitter.
5.
Release the Bind button after the receiver’s LED stays illuminated. This indicates the receiver is bound to
the transmitter.
6.
While the robot and transmitter are still powered on, remove the bind plug from the receiver.
7.
If the wheel aren’t moving as desired, it may be necessary to swap the Alieron
and Elevator plugs or to
reverse the channels on the transmitter. To reverse channels see the instructions for “Servo Reversing” in
the Spektrum documentation.
