Addressable RGB LED Controller and Remote
Important: Read all instructions prior to installation.
DS-SC (with DS-RT09)
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
Rev Date: V2 12/07/2020
5
yr
User Manual
Safety and Notes
• Product should be installed and serviced in accordance with applicable national,
state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit
breakers are switched off before performing any installation or wiring procedures.
DS-SC
1
2
3
W
4
5
6
7
8
9
0
DS-SC
1
2
3
W
4
5
6
7
8
9
0
speed
brightness
scene
ON/OFF
white
function
RGB channel
adjustment
mode
Pairing Remote(s)
Remote Layout and Functions
REMOTE(S) MUST BE PAIRED AS PART OF THE
INSTALLATION PROCESS AND DO NOT COME PRE-
PAIRED. EACH CONTROLLER CAN BE PAIRED TO UP
TO TEN (10) REMOTES.
To pair a remote, press match button on the controller, then
immediately press on/off button on the remote. Indicator
light on controller will flash slowly while attempting to
pair, then five times rapidly to indicate successful pairing.
To unpair a remote, hold match button for five seconds.
Indicator light on controller will flash five times rapidly to
indicate successful unpairing.
1: red, 2: green, 3: blue, 4: yellow,
5: magenta, 6: cyan, 7: orange, 8: purple,
9: light green, 10: natural white
Example Wiring Diagram
DS-SC
Addressable
RGB Strip
Power Supply
L
N
Mode
Once setup is complete (see page 2) press to cycle between
preprogrammed modes. Hold the upper mode (mode plus)
button for two seconds to run the mode cycle demo setting.
Hold the lower mode (mode minus) button for two seconds
to return to and run mode 1.
Speed
Press to adjust the speed of the selected preprogrammed
mode. Hold the upper speed (speed plus) button for two
seconds to select the fastest speed. Hold the lower speed
(speed minus) button for two seconds to select the slowest
speed.
Brightness
Press to adjust brightness in ten percent increments. Hold
for continuous 256 level adjustment.
RGB
Press to adjust in ten percent increments. Hold for continuous
256 level adjustment.
White
Press to turn white (RGB mix) on/off. Hold for continuous
256 level adjustment.
Scene
Each scene button can save one setting. Setting is saved
by holding scene button for two seconds. Press the scene
button after saving settings to recall those settings.
