Superabrasive
Owner’s manual original language – Lavina
®
LP36GE
1/2022
31
10. MAINTENANCE AND INSPECTION
Tampering w/emission control system prohibited.
Federal law and California State law prohibits the following acts or the causing thereof:
1.
The removal or rendering inoperative by any person other than for purposes of maintenance, repair, or
replacement, of any device or element at design incorporated into any new engine for the purpose of
emission control prior to its sale or delivery to the ultimate purchaser or while it is in use.
2.
The use of the engine after such device or element of design has been removed or rendered inoperative
by any person.
Among those acts presumed to constitute tampering, involve the parts/systems listed below:
-
Carburetor and internal parts ;
-
Spark plugs ;
-
Magneto or electronic ignition system;
-
Fuel filter element;
-
Air cleaner elements;
-
Crankcase;
-
Cylinder heads;
-
Breather chamber and internal parts;
-
Intake pipe and tube;
WARNING!
Before cleaning and servicing the machine, you must turn the machine off and disconnect battery and propane tank.
ATTENTION!
-
The exhaust will get very hot after running the engine for just a short time.
-
Before moving the machine from the working area, the machine must be cleaned.
-
All other equipment must be considered to be contaminated and be treated thereafter.
-
If possible, use a special suitable room.
-
Proper personnel protective equipment must be used.
-
After a service, all parts that are contaminated must be taken care of properly in plastic bags, according to all
regulations.
-
If the machine has to be used for other purposes, it is extremely important that the machine is cleaned to
avoid the spread of hazardous dust.
IMPORTANT: All major repair work should be performed by Superabrasive or an authorized repair facility.
Check and clean the Propane installation.
10.1 CHECK DAILY
After operating the LP36GE, the operator should conduct a visual inspection of the machine. Any defect
should be solved immediately.
10.2 CHECK AND REPLACE AFTER THE FIRST 8 WORKING HOURS
Replace the oil in the engine after the first 8 hours work, according to the instructions of the engine
manufacturer.
ALWAYS USE 30HD OR 10W-30 ENGINE OIL WITH ALL OF THE FOLLOWING RATINGS: SF, SG, AND CC.
