Superabrasive LAVINA ELITE 3213EHV, User Manual

Page: 14 / 42

Superabrasive
Owner’s Manual Original Language – Lavina
®
3213E/3213EHV 2/2020
14
4.6 STARTING THE MACHINE
Strictly follow the instructions in "SAFETY INSTRUCTIONS".
NEVER WORK WITH THE MACHINE WITHOUT MAINTAINING VISUAL CONTACT WITH IT.
First, follow the directions in the chapter on Safety Devices and Safety Instructions. If working wet, add water
to the floor surface. If working dry, instead switch on the vacuum unit. Next, pull the emergency stop (Fig.4.9-1) to
ensure that the machine can be started. Check the potentiometer (Fig.4.9-11) and ensure that it is set at the working
speed.
Finally, hold the machine firmly and turn the start button (Fig.4.9-3)
4.7 OPERATING THE MACHINE
Guide the machine in straight lines across the floor, slightly overlapping the previously completed surface with
each new line.
Work at a constant speed allowing the tools time to work at a speed appropriate for the tools’ grit size.
Avoid vibrations. Do not stop the
Lavina® 32E/32EHV machine in one spot while the tools are still working because
they will leave marks on the floor surface. When working wet, select the destination of the water feed with the water
tap (fig. 4.2-1) and periodically run the pump (fig. 4.9-5) to release water onto the floor surface. Starting the pump is
possible only if the machine motor is on. When working dry, check the floor surface periodically for dust accumulation.
Check regularly to see if your vacuum works properly
4.8 STOPPING THE MACHINE
The stopping of the machine must be done gradually until the motor stops. Do not stop moving the machine
before the motor comes to rest as the tools could damage the surface. To stop, switch the off switch (Fig.4.9-6). Use
the Emergency button (Fig.4.9-1) only in emergency or to fully disconnect power
Remember not to hold the machine in one spot before turning off the motor.
4.9 ALARM
The Alarm light ((Fig.4.9 -15) will light if the inverter goes in alarm mode. The most common failure is motor overload.
To reset the mode, push the reset button ((Fig.4.9-14).
5. TOOLS AND ACCESSORIES
TOOL HOLDER KEY
The tool holder key (Fig. 5.1) is used for adjusting, mounting and dismounting of the tools.
Always use the key for mounting.
Item number is A03.00.00.00
SECURITY PLATE FOR QUICKCHANGE PADS
Plate (Fig.5.2) used to sec
ure the “Quickchange” pads.
Item number is A64.00.01
Figure 5.1
Figure 5.2