Superabrasive LAVINA 38GR -X, User Manual

Page: 16 / 58

Superabrasive
Owner’s Manual Original Language – Lavina
®
38GR-X 08/2017
16
LOCAL CONTROL PANEL
1. Remote/Local/Start Engine switch
In position " Remote" the machine is controlled by REMOTE CONTROL
PANEL.
In position "LOCAL" the REMOTE CONTROL PANEL is not functioning
and the machine is controlled by the LOCAL CONTROL PANEL.
In this position the engine is in contact and it starts after switching the
switch to fully right position. After releasing the switch returns to
"LOCAL".
2. Water pump switch Lights orange when the water pump is working.
3. Ready switch "
ON/OFF”
In position
“ON”
after lighting the button a warning signal sounds.The
machine is powered by the battery and is ready to work.
In position “OFF”
the supply of the machine is interrupted and the
warning sound signal stops. This is the position in which the machine
should stay when the work is finished.
4. Digital RPM/workings hours indicator When
the motor runs it indicates the revolutions per minute of the motor -
see the conversion table to know the rpm of the tools. When the motor is not running, it indicates the worked hours.
The hour meter will blink between 48-52 hours as a reminder for an oil change.
5. Start/Stop clutch Start will electronically activate the grinding plates to spin; stop will disconnect engine from
grinding heads
6. Emergency stop button used in Emergency situations for stopping the machine.
7. Throttle Push forward to accelerate.
INDICATION UNITS ON THE ELECTRICAL CABINET
1. Indicator lamp "BATTERY" for charging the battery .
Lights when starting the engine and then extincts. The lighting of the lamp
during operation of the engine indicates faults in the battery charging
system.
2. Indicator lamp "FUEL" for LP Fuel Lockoff valve. Lights continuously
during operation.
Figure 4.11
Figure 4.14